Huawei P8 - Why Does My Phone Require Me to Register before Using the Speech Awareness Function

19.44.10 Why does my phone require me to register before using
the speech awareness function?
This requirement is to make your phone better learn your voice features and provide you a
better speech awareness experience.
19.44.11 Can I use a more complex voice instruction, for example,
music or navigation?
We hope to deeply research and optimize the most common and required voice input
scenarios. Therefore, currently, we design the voice instructions for making phone calls and
finding your phone. The instructions for playing music or performing navigation may be
planned in later versions.
19.44.12 Why does my phone call a different contact when I input
voice instructions?
Currently, the success identification rate can't achieve 100% in the industry. If the
pronunciations of two contacts are similar, your phone may incorrectly identify the voice
instruction. The voice identification algorithm engine will be further optimized.
19.44.13 Why isn't the flash on after my phone responds to my
speech awareness instruction?
When the battery level is higher than 20%, the flash is turned on to help you find your phone.
However, if the battery level is low, the flash is not on to save power.
19.44.14 Does the speech awareness function consume too much
power if it is always enabled?
This function appreciably increases the power consumption if it is always enabled. It doesn't
cause obvious impacts on your daily use. Therefore, you can enable it.
19.44.15 Why does my phone prompt "voice instruction failed to
be identified" when I speak with others?
The speech awareness function is incorrectly triggered. The noise may be recorded and
practiced when you practice the wakeup keywords. Try practicing the wakeup keywords in a
quiet environment. This function will be further optimized.
19.44.16 Can I set the wakeup keywords?
Yes.
19.44.17 How do I set the wakeup keywords?
Touch Settings. In All, go to Smart assistance > Speech awareness. Touch Wakeup
keyword type and then Custom wakeup keyword. Set new wakeup keyword type according
to the onscreen instructions.