EasyManua.ls Logo

Huawei S6700 Series

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
[SwitchA] ipv6
[SwitchA] interface vlanif 10
[SwitchA-Vlanif10] ipv6 enable
[SwitchA-Vlanif10] ipv6 address 1::1/64
[SwitchA-Vlanif10] quit
[SwitchA] interface vlanif 20
[SwitchA-Vlanif20] ipv6 enable
[SwitchA-Vlanif20] ipv6 address auto link-local
[SwitchA-Vlanif20] quit
The configurations of Switch B and Switch C are similar to the configuration of Switch A and
are not mentioned here.
Step 3 Configure the PCs.
Configure the default gateway addresses of PC1, PC2, and PC3 to 1.1.1.1, 1.1.2.1, and 1.1.3.1
respectively.
Step 4 Configure IPv6 static routes.
# Configure a default IPv6 route on Switch A.
[Switch A] ipv6 route-static :: 0 vlanif20 FE80::218:20FF:FE00:80
# Configure two IPv6 static routes on Switch B.
[Switch B] ipv6 route-static 1:: 64 vlanif20 FE80::218:20FF:FE00:81
[Switch B] ipv6 route-static 3:: 64 vlanif40 FE80::218:20FF:FE00:82
# Configure a default IPv6 route on Switch C.
[Switch C] ipv6 route-static :: 0 vlanif40 FE80::218:20FF:FE00:83
Step 5 Configure the addresses and the gateway addresses on the PCs.
Assign the IPv6 addresses to the PCs according to the networking diagram. Set the default
gateway address on PC1 to 1::1, the default gateway address on PC2 to 2::1, and the default
gateway address on PC3 to 3::1.
Step 6 Verify the configuration.
# Check the IPv6 routing table of Switch A.
[Switch A] display ipv6 routing-table
Routing Table :
Destinations : 5 Routes : 5
Destination : :: PrefixLength : 0
NextHop : FE80::218:20FF:FE00:80 Preference : 60
Cost : 0 Protocol : Static
RelayNextHop : :: TunnelID : 0x0
Interface : Vlanif20 Flags : D
Destination : ::1 PrefixLength : 128
NextHop : ::1 Preference : 0
Cost : 0 Protocol : Direct
RelayNextHop : :: TunnelID : 0x0
Interface : InLoopBack0 Flags : D
Destination : 1:: PrefixLength : 64
NextHop : 1::1 Preference : 0
Cost : 0 Protocol : Direct
RelayNextHop : :: TunnelID : 0x0
Interface : Vlanif10 Flags : D
Destination : 1::1 PrefixLength : 128
NextHop : ::1 Preference : 0
Cost : 0 Protocol : Direct
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 1 IP Static Route Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
16

Table of Contents

Other manuals for Huawei S6700 Series

Related product manuals