Huawei WS319 - Setting Dial-Up Connection Parameters

15
The user name and password are provided by Internet Service
Provider (ISP). Set up a dial-up connection on one computer
only.
Connect with another
modem
3. Set WLAN parameters.
– If you selected Connect with user account，enter the parameters provided by your
Internet Service Provider (ISP) and click Next.
– If you selected Connect without user account or Connect with another modem, click
Next.
4. Choose Home tab, click Set Up WLAN, set WLAN parameters, click Save.
Setting Dial-Up Connection Parameters
When the WS319 works in Bridge mode you need to perform this operation. Otherwise you do
not need to perform this operation.
Before setting dial-up connection parameters, verify that the WS319 is correctly connected to
your computer and you have the dial-up connection account name and password provided by
your Internet service provider (ISP). This section demonstrates how to set up a Point-to-Point
Protocol over Ethernet (PPPoE) connection on Windows.
On Windows 7
1. Choose Start > Control Panel > Network and Internet > Network and Sharing Center.
2. Under Change your networking settings, click Set up a new connection or network.
3. In the Set Up a Connection or Network window, select Connect to the Internet and click
Next.
If you selected Connect with user account or Connect without user account
, the computer
automatically connects to the Internet as long as the router is working properly.
To obtain the default SSID and key, check the label on the rear panel. To better secure your
WLAN, promptly change the SSID and key.