PSP8620311
Rev. E
25
8. Repeat from Step 3 to 7 for an item called “USB Serial Port”; drivers are now installed.
NOTE: The installer must run twice. Once to install the radio driver itself and then again to
install the USB Serial Port
NOTE: Refer to the "VTI Communication Troubleshooting Guide VT1-APR0013" which
is available on the Hubbell Power Systems website for more detailed instructions on
installing the local radio drivers.
6 — Control Programming
9. After the radio drivers have been correctly double installed the local radio would
appear in the Device Manager under ports (COM & LPT) section as below.
1. Digi PKU-G Serial Adapter(COMXX) for a Digi Local Radio
2. HPS Local Radio(COMXX) for a Siflex High Performance Radio.
To Next Page
Loading...
