PSP8620311
Rev. E
10
3 — Receiving & Handling
NOTE: When batteries are removed for
more than seven days, the time stamp
chip will stop keeping time. If time stamp
feature is required, the time stamp can
be reset before placing the recloser in
service. (See Section 7.)
Storage
If the recloser is not going to be put into service
immediately, re-pack all components in the
factory package to minimize storage damage
and to ensure good operating conditions in the
future. Hubbell Power Systems recommends
that the recloser be stored indoors or under
cover, off the ground, not subject to direct sun,
rain or snow.
If the storage area temperature exceeds
100°F, remove the batteries and store in a
cool, dry area.
Unpacking
1. Locate the Hubbell USB Drive that is
enclosed with this manual. The USB
drive should be in the custody of the
personnel who will be responsible for the
programming of the recloser.
1. Carefully remove all items from the
packaging. Exercise caution and do not
drop the unit or strike the skirted end on
anything as this may damage the vacuum
interrupter or mechanism.
1. Refer to Figure 3-1 to familiarize yourself
with all components.
Figure 3-1 Components
Mounting
Fasteners
and
PG Clamps
Battery Bayonet
Insulator
Radio
(optional)
Instructions,
Flash Drive
and NR
Handle
Adapter Kit.
Mounting
Brackets
Inspection
1. Inspect the packaging for obvious
shipping damage.
2. Open and thoroughly inspect the product
for hidden damage.
3. Note any damage on the “Bill of Lading”
prior to accepting the delivery.
4. Check the material nameplate against the
shipping list to ensure the correct material
has been received. In case of shortage
or incorrect material, immediately notify
your factory representative or customer
service.
NOTE: Documentation of visible
shipping damage can determine the
outcome of any damage claim. Notifying
the carrier of concealed damage within
15 days is essential to resolving or
minimizing unsettled claims. Immediately
file your claim and notify your factory
representative.
To Next Page
Loading...
