PSP8620311
Rev. E
46
9 — Trouble Shooting
The following table presents possible symptoms, their possible cause(s) and likely corrective action(s). These do not cover all possible problems.
For more detailed communication and troubleshooting guides, please visit the Hubbell Power Systems website. If you are unable to correct a
problem using this trouble shooting guide, contact your local Hubbell representative or Customer Service at (573) 682-5521.
Table 9-1 Trouble Shooting Guide
Recloser does a) Handle not in full closed position a) Make sure handle fully closed (up)
not close b) Batteries low b) Replace batteries
Recloser does a) Non-reclosing lever is down a) Move non-reclosing lever to up position
not automatically
reclose
Recloser a) Damaged mechanism a) Consult factory representative
does not open
Programming a) Bad cable a) See Section 6 for cable specification
software does not b) Bad cable connection b) Ensure good connection for cable on both ends
communicate with c) Communication port unselected or c) Ensure port is selected and connected cable
recloser incorrectly selected matches port selected
Corrective Action(s)
Possible Cause(s)Symptom
To Next Page
Loading...
