Hubner EGS 40 Series User Manual

Electronic Overspeed Switch EGS 40
EGS40_MANUAL-en_R6(2018-11-07)ID74528.docx
29
11 Replacement parts
The replacement parts listed below can be obtained via the service address on page 2.
Replacement parts
Comment
Terminal box cover
Including flat seal and screws
Feather key
Specify shaft dimensions or feather key dimension
Cable gland
M 20 x 1.5
Terminal box – screw plug
Specify shaft dimensions or feather key dimension
Cover
Cover for the 2nd shaft end or for the hollow shaft bore (gAS)
Axial tensioning disk / ring
For hollow shaft design
Screw plug
For hollow shaft combinations To seal access to the axial
tensioning disk
Programming cable and software
NOTE!
When ordering replacement parts always specify the serial number of the device!

Hubner EGS 40 Series Specifications

General

Brand	Hubner
Model	EGS 40 Series
Category	Switch
Language	English