– 4 –
PAIRING MULTIPLE REMOTES to a Single Network ID
Each PowerView Remote comes with its own
unique Radio Frequency (Network) ID. If
multiple remotes (ie. PowerView Pebble
®
and/
or PowerView Surface remotes) will be used in
the home, it is necessary to establish a single
PowerView Shade Network ID for all remotes
before any window covering programming is
done. This is to ensure that if a PowerView
Hub, PowerView Scene Controller or PowerView
Repeater(s) will be used in the future, it can
be used to operate previously programmed
window coverings in the home and be used in
conjunction with all the remotes on a single,
unified network.
q
SELECT the initial Network remote. This
will be the source remote from which a
unified PowerView Shade Network will be
established for the home.
NOTE: Because a unified network has not
yet been established, it does not matter
which available remote you choose to use to
create a PowerView Shade Network.
w
SELECT the target remote.
e
REMOVE the back cover on the target
remote.
r
Using a ball point pen, PRESS and HOLD
the recessed Reset button on the back of
the target remote for six seconds.
NOTE: The Group numbers (1-6) buttons
will flash twice on the press of the Reset
button, then again at six seconds.
t
REINSTALL the back cover onto the
target remote.
y
PRESS and HOLD (Stop) on the source
remote, until indicator lights begin to blink.
NOTE: This puts the source remote in
Programming Mode. Indicator lights on the
source remote will continue to blink for 20
seconds following each set of commands,
allowing additional target remotes to
be networked.
q
e
w
r
t
y
Source
Target
Target
Target
Target
Source
Target
To Next Page
Loading...
Need help?
General