OPERATION
18
Raising and Lowering the Blind — SimpleLift
™
Operating System
To Raise the Blind:
IMPORTANT: Prior to raising or lowering, tilt the slats to the open position using the wand
on the left or right side of the blind.
Grasp the bottom rail near the center with one hand while balancing the bottom rail with
your other hand.
Fully press the center button with your thumb and gently lift the bottom rail.
Allow the slats to stack evenly by gradually lifting the bottom rail while the center button
is fully depressed.
Hold the bottom rail stationary at the desired position while releasing the button.
For inside mount blinds: When raising the blind, pull the bottom rail slightly toward
you. Press the center button and gently raise the bottom rail. Once the desired height is
reached, release and place the blind back into the window opening and the blind will stay
in that position.
To Lower the Blind:
IMPORTANT: Prior to lowering the blind, fully press the center button with your thumb and
pull the bottom rail down to the desired height.
Hold the bottom rail stationary at the desired position while releasing the button.
For inside mount blinds: When lowering the blind, pull the bottom rail down and slightly
toward you. Release the button and place the bottom rail onto the sill.
To Next Page
Loading...
Need help?
General
