INSTALLATION
15
Complete the Installation
Attach the Hook Wand (If Ordered)
If the blind was ordered with a hook wand, attach the wand to the metal shaft.
Pull the plastic sleeve from the top of the wand and insert it over the metal shaft.
Insert the hook on the wand through the hole in the metal shaft.
Slide the plastic sleeve down over the hook until firmly seated.
Test the wand. Approximately six revolutions of the wand should tilt the slats from fully
closed up to fully closed down.
Attach the Snap-On Wand (If Ordered)
If the blind was ordered with a snap-on wand, attach the wand to the metal shaft.
Connect the snap-on wand to the metal shaft.
Test the wand. Approximately six revolutions of the wand should tilt the slats from fully
closed up to fully closed down.
Plastic
Sleeve
Hook
Metal
Shaft
Slide
Sleeve
Over
Shaft
Hook
Through
Hole
Slide
Sleeve
Over
Hook
Snap-on
Connector
Wand
Metal
Shaft
Push
Up to
Attach
Wand
Check for
Secure
Attachment
Hook Wand
Snap-on Wand
W
and
Plastic
Sleeve
Hook
Metal
Shaft
Slide
Sleeve
Over
Shaft
Hook
Through
Hole
Slide
Sleeve
Over
Hook
Snap-on
Connector
Wand
Metal
Shaft
Push
Up to
Attach
Wand
Check for
Secure
Attachment
Hook Wand
Snap-on Wand
Wand
To Next Page
Loading...
Need help?
General
