INSTALLATION
9
Drill the screw holes using a
3
⁄
32
" drill bit.
Attach the hidden installation brackets using the
screws provided.
IMPORTANT: The front edges of the hidden
installation brackets must align.
Proceed to “Install the Blind” on page 14.
Mount the Beveled Box Installation Brackets
— Outside Mount (Commercial Applications)
To attach the beveled box installation brackets, a flat vertical surface of at least
5
⁄
8
" is
required for both
1
⁄
2
" and 1" slat sizes.
Mark the Beveled Box Installation Bracket Locations
Mark where the ends of the headrail will be located.
Center the headrail over the window opening at the desired height.
Use a pencil to lightly mark each end of the headrail.
Alternatively, measure the width of the headrail and use that
width to mark the headrail end points over the window
opening.
Make a second mark
1
⁄
4
" to the outside of the
headrail end marks. The outer marks are
where the outside edges of the
beveled box installation
brackets will be located.
5
∕
8
" Minimum
Flat Vertical Surface
Mark
Measure and Mark
1
∕
4
" Out from
Ends of Headrail
Mark
To Next Page
Loading...
Need help?
General
