OPERATION
17
Operate the Blind
Tilting the Slats
Wand tilt (not shown): Rotate the wand to tilt the slats
to the desired angle.
Cord tilt (LiteRise
®
Only): The two cords with individual
tassels are for tilting the slats. Each cord tilts the slats in
an alternate direction.
Raising and Lowering the Blind — Standard Cordlock System
IMPORTANT: Whenever raising or lowering the blind, the slats must be in the open position.
Pull the single cord down and toward the center to raise and lower.
Hold the single cord to the outside to lock the blind in position.
Raising and Lowering the Blind — LiteRise Operating System
IMPORTANT: Whenever raising or lowering the blind, the slats must be in the open position.
Grasp the handle or bottom rail
and push up to raise the blind.
Grasp the handle or bottom rail
and pull down to lower the blind.
Raise and
Lock into
Position
To Next Page
Loading...
Need help?
General
