OPERATION
20
Problem
SimpleLift
™
blinds only: The bottom rail is not level or the blind height is
incorrect.
Solution
Check that the headrail and installation brackets are level and aligned. Adjust
and/or shim the installation brackets to level, if necessary.
Level the Bottom Rail or Correct Blind Height:
NOTE: All skew adjustment features are located under the headrail.
To level the blind, raise the low side of the
bottom rail by turning the skew adjustment
feature on the headrail clockwise with a coin
or screwdriver while lifting the weight from
the bottom rail.
NOTE: Turn the skew adjustment that is
on the same side as the low side of the
bottom rail.
If the blind height is too long, turn all of the
skew adjustment features clockwise to raise
the entire bottom rail to the desired height
while lifting the weight from the bottom rail.
Problem
SimpleLift blinds only: The blind makes a ratcheting noise while the center
button is pushed in and the bottom rail is being raised.
Solution
Push harder on the center button. The button must be fully depressed to raise
or lower the blind.
To Next Page
Loading...
Need help?
General
