INSTALLATION
9
STEP 3 — Install the Shading
Mount the Headrail
■ Peel back the protective covering
from the top of the Palette
®
fabric-
covered headrail. Leave the rest
of the protective covering on the
front of the headrail.
■ Position the shading so that the front faces you.
■ Slide the headrail into the installation brackets so the edge of the headrail is
between the lever and the bracket, asshown.
■ Firmly push the headrail into each bracket until it clicks and the lever snaps
to the right side of the bracket.
IMPORTANT: Carefully pull on the headrail at each bracket to ensure it is
installedsecurely.
■ Completely remove the protective covering from the Palette fabric-covered headrail.
Attach the Dust Cover (Optional)
The dust cover can be used with outside mounts to protect the top of
the headrail from exposure.
■ Cut the dust cover to desired width.
■ Remove the paper backing on one side of the hook and loop fastener dots.
■ Apply the dots to the installation brackets on each end of the shading.
■ Remove the remaining paper backing from the dots.
■ Center the dust cover over the top of the shading, above the dots.
■ Press the dust cover down onto the dots.
Paper
No Dust Cover
Headrail
Installation Bracket
Slide the Headrail
Between the Lever
and the Bracket
To Next Page
Loading...
Need help?
General
