CARE
24
Removing the Shading
■ Fully raise the rear shade and front shading.
■ Move each lever of the installation brackets to the left to
release the shading.
➤ A flat blade screwdriver can be used to move the lever.
CAUTION: Be very careful to not tear or damage any of
thefabric.
➤ If the lever is inaccessible
or inoperable, lower the
shading until you can see
the underside of the bracket.
Carefully reach a thin flat
blade screwdriver behind the
shading to the tab on bottom
of the bracket between the
screw holes.
➤ Push the tab away from the
shading and pull the headrail
to release it from the bracket.
■ Carefully pull the shading to
remove it from the brackets.
Cleaning Procedures
Silhouette
®
and Nantucket
™
window shadings are made of 100% polyester, which means they
are inherently durable and resilient. However, care must be taken to avoid wrinkling the fabric,
particularly where the vanes meet the facings.
Cleaning the Palette
®
Fabric-Covered Headrail
Spot-clean the headrail using a sponge or delicate cloth, cool distilled water and a mild soap
solution; handle with care as you would any fine fabric.
Cleaning the Front Silhouette or Nantucket Shading
Dusting
Regular light dusting with a feather duster is all the cleaning needed in most circumstances.
Vacuuming
Use a low suction, hand-held vacuum for more thorough dust removal.
Move the lever to the left
to release the shading.
Top View
Tab
Underside of
Bracket
End Cap
To Next Page
Loading...
Need help?
General
