14
Adjustments and Operation
Battery Life
The Wireless Rain-Clik transmitter is designed to
operate up to 10 years with its sealed, maintenance-free
battery. The transmitter is available as a replacement
part (WRCLIK-TR). Should you need to change the
transmitter, the receiver will have to learn the new
transmitter address.
To Check the Status of the Battery in the
Transmitter
1. Press and hold the quick response spindle at the top of
the sensor.
2. Within a few seconds the LED light on the bottom of
the sensor will briey ash.
3. Release the spindle and the LED light will ash again. If
the LED ashes, the battery in the transmitter is good.
If you are experiencing problems with your Wireless Rain-
Clik sensor, follow these simple checks rst before
assuming the unit is defective and replacing it.
System Will Not Turn On at All
• Check to make sure that the sensor discs are dry and
the switch “clicks” on and o freely by pressing the
top of the spindle.
• Look for breaks in the wire leading to the receiver and
check all connections.
• Verify outside air temperature (for Rain/Freeze-Clik
installations).
System Will Not Shut O Even Aer Heavy Rainfall
• Remove the sensor jumper across the two SEN
terminals. Check to make sure that rainfall is hitting
the sensor.
• Look for breaks in the wire leading to the receiver and
check all connections.
• Check the battery in the transmitter.
Sensor Bypass LED Is Flashing Red
• Check that the battery in the transmitter is good.
• Check for obstructions around the transmitter or
receiver antenna.
To Next Page
Loading...
Need help?
General
