Hunter Rain-Clik - Mounting the Receiver: Advanced Wiring; Wiring to Hydrawise-Enabled Controllers; Wiring for Normally Closed Sensor Applications

9
Mounting the Receiver
Wiring the Receiver to a Hydrawise
TM
-Enabled
Controller
1. Attach the two yellow wires to the 24 VAC terminals.
2. Attach the blue wire to one SEN terminal and the white
wire to the SEN COM terminal.
Wiring the Receiver to Other Controllers: Normally
Closed Sensor Applications
3. Attach the two yellow wires to the 24 VAC terminals.
4. Attach the blue and white wires to the sensor terminals
(if available) or in-line with the valve common wire.
P MVC AC AC
W
B
Y
Y
O
Common wire
to all valves
Used for normally
open sensor
applications
SENSOR STATUS
SENSOR BYPASS
Press to bypass, press
again to re-enable
GREEN = Sensor is dry
RED = Sensor is wet
Red light indicates
sensor is bypassed
RAIN SENSOR BYPASS
ACAC GND SEN
SEN
SEN
COM
W
B
Y
Y
O
Common wire
to all valves
Used for normally
open sensor
applications
SENSOR STATUS
SENSOR BYPASS
Press to bypass, press
again to re-enable
GREEN = Sensor is dry
RED = Sensor is wet
Red light indicates
sensor is bypassed
RAIN SENSOR BYPASS