Hunter SVC-400 - Programming the Controller (WVP) - Advanced; Selecting Specific Days of the Week to Water; Selecting Interval Watering; Transmitting;Receiving Data

®
32
33
Selecting Specic Days of the Week to Water
The controller will display the
station number and 7 days of
the week with a icon or a
icon above the numbered day.
The icon would represent an
“On” water day, while the
icon would represent an “Off” watering day.
1. Press the button to navigate to the
desired station.
2. With the cursor on a specic day (the
cursor always starts with 1), press the
button to activate a particular day of
the week to water. Press the button to
cancel watering for that day. After pressing
a button the cursor automatically advances
to the next day.
3. Repeat step 1 until all desired days have
been selected. The selected days will show
with a to indicate their status ON. The last
is the last watering day for the program.
4. Press the button to navigate to the next
station.
5. Repeat steps 1 through 3 for each station.
NOTE: If interval watering is selected, make sure
the interval mode is displayed prior to navigating
to the next station.
Selecting Interval Watering
With this option you can select
interval watering from 1 to 31
days.
1. Use the button to navigate
to the desired station.
2. With the cursor on day 7, press the
button until the interval watering icon
will be displayed along with the interval
(ashing).
3. Press the or button to select the
number of days between watering days (1
to 31). This is called the interval. (Pressing
the at anytime during the interval setup
will advance back to specic days of the
week to water.)
4. Use the button to advance to the next
station number.
The controller will water at the next Start
Time and will then water at the interval
programmed.
Transmitting/Receiving Data
All program information and manual watering
is conducted with the WVP and individual
WVC controllers using radio signals. Under
normal conditions, these operations can be
conducted up to 100 feet from the controller.
The transmit/receive button on the handle of
the WVP is used to transmit or receive data.
WVP
WVC
Entering the WVC Identication Code
Each WVC controller has a unique 3-digit
identication code that is established during
the installation of the controller. This unique
code allows for added security and radio
operation with individual controllers on a
site that has multiple WVC controllers. To
establish radio contact with a WVC, you must
know the unique identication code that was
established during the initial setup of
the WVC controller (refer to page 30
for information on setting or changing
the identication code for your
controller).
1. Press the Transmit/Receive button
on the WVP handle. The lower portion of
the display will illuminate. The Transmit/
Receive arrow will be ashing.
2. Use the or button to enter the unique
WVC identication code from 0 to 999.
You can now establish radio contact with
the WVC.
Transmitting Programs
Once the WVC 3-digit identication code is
entered into the WVP:
1. Use the button to select the transmit
function (the arrow will be ashing).
PROGRAMMING THE CONTROLLER (continued)