Compliance Information
© 2020 Hunter Industries™. Hunter, the Hunter logo, and all other
trademarks are property of Hunter Industries, registered in the U.S.
and other countries.
Please recycle.
RC-174 US 11/20
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, you
are encouraged to try to correct the interference by taking one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that of which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may cause undesired operation.
Changes or modications not expressly approved by Hunter Industries could void the
user’s authority to operate this device. If necessary, consult a representative of Hunter
Industries. or an experienced radio/television technician for additional suggestions.
The following statement is applicable when irrigation controller is used with accessory
Wi-Fi device: To satisfy FCC RF Exposure requirements for mobile and base station
transmission devices, a separation distance of 7.9" (20 cm) or more should be maintained
between the antenna of this device and persons during operation.
To ensure compliance, operation at closer than this distance is not recommended. The
antenna(s) used for this transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Certicate of Conformity to European Directives
Hunter Industries declares that the irrigation controller complies with the
standards of the European Directives of “electromagnetic compatibility”
(2014/30/EU), “low voltage” (2014/35/EU), and “radio equipment”
(2014/53/EU).
Innovation, Science and Economic Development Canada (ISED) Compliance Notice
This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage, et
2. L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.
HUNTER INDUSTRIES | Built on Innovation
®
1940 Diamond Street, San Marcos, CA 92078 USA
Learn more. Visit hunterindustries.com
To Previous Page
Loading...
