OPERATION INSTRUMENTS
- 16 -
ENGLISH
COMPRESSION DAMPING OF FORK
Hydraulic compression damping determines the reaction when the fork
is compressed. The degree of compression can be adjusted with adjus-
ting screws at the bottom of the fork legs.Remove the protecting cap (1).
Turn the adjusting screws (2) clockwise to increase damping, turn it coun-
terclockwise to reduce damping during compression.
STANDARD ADJUSTMENT
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of
fork
Typ White Power 14457A01 ................22 clicks
Typ White Power 14457A02 ................18 clicks
Typ White Power 14457A03 ................20 clicks
REBOUND DAMPING OF FORK
Hydraulic rebound damping determines the reaction when the fork is
rebound. By turning the adjusting screw (3) (REB), the degree of
damping of the rebound can be adjusted. Turn the knob clockwise to
increase damping, turn it counterclockwise to reduce damping during
rebounding.
STANDARD ADJUSTMENT
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of
fork
Typ White Power 14457A01 ................20 clicks
Typ White Power 14457A02 ................20 clicks
Typ White Power 14457A03 ................15 clicks
1
2
2
3
3
To Next Page
Loading...
