MAINTENANCE WORK ON CHASSIS AND ENGINE
- 51 -
ENGLISH
CHANGING THE ORIGINAL POSITION OF THE
CLUTCH LEVER
The adjusting screw (1) can be used for individual adjustment of the ori-
ginal position of the clutch lever, thus allowing adjustment to an optimal
position for every hand size.
Turning the adjusting screw clockwise reduces the distance
between the clutch lever and the handlebar. Turning the adjusting screw
counterclockwise increases the distance between the clutch lever and the
handlebar.
CAUTION: Adjustment of the clutch lever position is only
possible within certain limits. Only turn the adjusting screw
manually and never apply excessive force.
CHECKING THE OIL LEVEL OF THE HYDRAULIC
CLUTCH
To check the oil level in the master cylinder of the clutch remove the cover.
For this purpose, remove screws (2) and cover (3) together with the rub-
ber boot (4). The oil level in the horizontal-standing master cylinder should
be 4 mm below the upper edge.
If necessary, fill up with biodegradable hydraulic oil SAE 10 (e.g. Moto-
rex Kupplungs-Fluid 75).Biodegradable hydraulic oil is available from
your Husaberg dealer (50ml).
CAUTION: Husaberg uses biodegradable hydraulic oil for the
hydraulic clutch control. Never mix biodegradable hydraulic
oils with mineral oils. Never refill with mineral hydraulic oil
or brake fluid.
BLEEDING OF THE HYDRAULIC CLUTCH *
To bleed, the cover of the master cylinder of the clutch needs to be
removed. For this purpose, remove screws (2) and take off cover (3) toget-
her with rubber bellows (4). At the slave cylinder of the clutch, remove
the bleeder nipple (5). In its place, mount the bleeder syringe (6) which
is filled with SAE 10 hydraulic oil. Refill oil until oil is discharged from the
bore (7) of the master cylinder in a bubble-free state. Make sure that the
oil does not overflow. The bleeder syringe can be purchased from your
Husaberg dealer.Having completed the bleeding procedure, you have to
verify that the oil level in the master cylinder is correct.If necessary, fill up
with biodegradable hydraulic oil SAE 10 (e.g. Motorex Kupplungs-Fluid
75). Biodegradable hydraulic oil is available from your Husaberg dealer
(50ml).
CAUTION: Husaberg uses biodegradable hydraulic oil for the
hydraulic clutch control. Never mix biodegradable hydraulic
oils with mineral oils. Never refill with mineral hydraulic oil
or brake fluid.
1
2
3
4
5
6
7
To Next Page
Loading...
