HUSABERG "05 - Maintenance Work on Chassis and Engine; Checking and Adjusting the Steering Head Bearing

PERIODIC MAINTENANCE SCHEDULE
- 27 -
ENGLISH
RECOMMENDED INSPECTION OF THE HUSABERG - ENGINES USED FOR ENDURO COMPETITIONS BY YOUR HUSAB-
ERG WORKSHOP (ADDITIONAL ORDER FOR THE HUSABERG WORKSHOP)
a 100 liter fuel consumption is equivalent to approx.
15 operating hours
15
hours
100 liter
30
hours
200 liter
45
hours
300 liter
60
hours
400 liter
90
hours
600 liter
120
hours
800 liter
135
hours
900 liter
Check the clutch disks for wear
z z z z z z z
Check the length of the clutch springs
z z z z z z
Check the cylinder and piston for wear
z z z
Check the groove on the piston pin retainer for wear
(visual check)
z z z
Check the camshaft for wear (visual check)
z z z
Check the camshaft bearings
z z z
Check the length of the valve springs
z z z
Check the spring cap for wear
z z z
Check the eccentricity of the valve disk
z z z
Check the valve guides for wear
z z z
Check the radial clearance of the rocker arm rollers
z z z
Check the elongation of the timing chain
z z z
Check the chain tensioner tooting for damage
(visual check)
z z z z z z
Check the eccentricity of the crankshaft journal
z z z
Replace the conrod bearings
z z z
Check piston pin bearing
z z z
Replace the balancer shaft bearings
z z z
Replace the crankshaft main bearings
z z z
Check the entire transmission including the roller and
bearings for wear
z z z