MAINTENANCE WORK ON CHASSIS AND ENGINE
- 45 -
ENGLISH
TIRES, AIR PRESSURE
Tire type, tire condition, and air pressure level affect the way your
motor-cycle rides and must therefore be checked whenever you
are getting ready to go anywhere on your motorcycle.
–Tire size can be found in the technical specifications and in the
homologation certificate
–Tire condition has to be checked every time you want to ride
your motorcycle. Before leaving, check tires for punctures and
nails or other sharp objects that might have become embedded
in them.
– Refer to the specific regulations in your country for minimum tire
tread requirements. We recommend you replace the tires at the
latest when the tread is down to 2 mm (0.08 in).
–Tire pressure should be checked regularly on a “cold” tire.
Proper pressure ensures optimum driving comfort and extends
the life of your tires.
WARNING: Do not mount tires which have not been
approved by Husaberg. Other tires could have adverse
effects on the way your motorcycle behaves.
Front and rear wheels may only be fitted with tires
having the same tread layout. Use homologated tires.
For your own safety replace damaged tires immediately.
Worn tires can have a negative effect on how your
motorcycle performs, especially on wet surfaces.
If air pressure is too low, abnormal wear and overheating
of the tire can result.
CHECK/SET DISTANCE OF THE MAGNETIC SENSOR
The distance between magnet (2) and sensor (1) must be 2-4 mm
(0,08-0,16 in), otherwise malfunctions on the speedometer might
occur.
This distance can be corrected by screwing in or off the sensor (1).
front rear
Off-road FC/FE 1,0 bar 1,0 bar
Road FE 1,5 bar 2,0 bar
Road FS 1,5 bar 2,0 bar
TIRES PRESSURE
1
2
1
To Next Page
Loading...
