HUSABERG Edition 2004 - CHECKING THE ENGINE OIL LEVEL; CHANGING THE ENGINE OIL *

MAINTENANCE WORK ON CHASSIS AND ENGINE
- 55 -
ENGLISH
CHANGING THE OIL FILTER
Place a suitable vessel under the engine to allow the oil to drain.
Remove both screws (1) and screw an M6 screw in the center hole
(2) of the oil filter cover.
NOTE: only tighten the screw by hand, otherwise you will
damage the oil filter cover.
Pull the oil filter cover (3) out of the hole with the screw M6 and
remove the screw.
Use pliers to pull the oil filter element (4) from the housing.
Clean the oil filter cover, the sealing areas on the O-rings and the
engine case. check the O-rings (5) in the
oil filter cover for damage and replace if necessary.
Lay the motorcycle down and fill the oil filter housing approx. half-
full with engine oil. Insert the oil filter in the housing.
Grease the O-rings in the oil filter cover and mount the cover.
Mount the screws and tighten to 6 Nm.
Place the motorcycle in an upright position again.
Unscrew the oil filler plug (6) and add 1 liter of fully synthetic
engine oil (e.g.: Motorex Power Synt. 4T).
Start the engine and check all of the plugs and the oil filter cover
for leakage.
Finally, check the engine oil level and correct if necessary.
1
1
5
5
2
3
4
6