HUSABERG FE 450 User Manual

DISMOUNTING AND MOUNTING THE ENGINE
B
5
MOUNTING THE ENGINE
–Lift the engine into the frame, position the engine
mounting plates (1), insert the bolts and screw on the
nuts but do not tighten yet.
– Position the swing arm and push in the swing arm
pivot (2) from the right until it touches the engine.
– Lift the engine until the swing arm pivot can be
pushed through the engine case, gently tapping with a
plastic hammer if necessary.
– Screw the nut on the swing arm pivot and tighten to
100 Nm.
–Tighten the nuts on the engine mounting plates to
25 Nm.
– Insert the carburetor in the front carburetor connection
boot and tighten the clamps.
–Mount the rear carburetor connection boot (3) and
tighten the clamps
2
1
3

HUSABERG FE 450 Specifications

General

Engine Type	Single cylinder, 4-stroke
Displacement	449.3 cc
Bore x Stroke	95 mm x 63.4 mm
Compression Ratio	11.8:1
Starter	Electric starter
Transmission	6-speed
Lubrication	Pressure lubrication with 2 oil pumps
Cooling	Liquid cooling
Fuel System	Keihin EFI
Ignition	Digital CDI