4.4.1.2 Follow guide wire and boundary wire
The time interval can be set for when the product starts
to follow the boundary wire and guide wire to find the
charging station.
4.4.2 Lawn coverage
4.4.2.1 GPS assisted navigation
The product has
GPS Assisted Navigation
that helps
the product to select the most optimal operation. This
function is enabled from the factory. If you want to do
manual settings for your lawn, disable the
GPS Assisted
Navigation
and make settings for
Area 1-5
. Disable
the
GPS Assisted Navigation
if you want to use the
Systematic Passage Mowing
function and make settings
for
Area 1-5
. Refer to
Settings for Area 1-5 on page 22
.
4.4.2.2 Settings for Area 1-5
Use this function if the work area includes remote
parts that are connected with narrow passages to keep
a satisfactorily cut work area. The
Lawn Coverage
function is used to cut remote parts of the work area.
The
Systematic Passage Mowing
function is used to
cut in narrow passages. A guide wire must be installed
to use these functions. You can set a maximum of 5
remote areas where the product starts to cut.
The
Systematic Passage Mowing
function is applicable
for narrow passages of 60 cm - 1.5 m / 23 in. - 4.9
ft. width. The product moves in a pattern to cut the
full passage width. The product starts the
Systematic
Passage Mowing
at the set distance from the charging
station. When the product is at the end of the narrow
passage, the product continues to cut the work area as
usual.
You can set the product to follow the guide wire to the
set specified distance before it starts to cut.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
Each area can be enabled or disabled. Use the
Test
function to measure the distance from the charging
station to where the product must start to cut. Refer to
To measure the distance from the charging station on
page 22
.
The default settings lets the product follow the guide
wire 300 m / 980 ft. in 20% of the times it moves out
from the charging station. If the guide wire is less than
300 m / 980 ft. the product will follow it to the point
where the guide wire is connected to the boundary wire.
4.4.2.3 To measure the distance from the charging
station
The product follows the guide wire to measure the
distance to the charging station.
1. Put the product in the charging station.
2. Select
Test: Area 1 setup
or
Test: Area 2 setup
to
measure the distance.
3. Push the STOP button to show the distance in the
app.
4.4.3 Corridor width
The boundary wire corridor is the area adjacent to
the boundary wire. The product uses the corridors to
find the charging station. The corridor width is adjusted
automatically. If it is necessary to adjust the corridor
width manually for the product to operate satisfactorily,
you can set the corridor width between 1-9.
4.4.4 Reversing distance
The reversing distance makes the product move in
reverse for a set distance, before the product starts to
cut the lawn.
4.4.5 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance. Then the product
moves rearward and changes direction. The factory
setting is 32 cm / 13 in. You can select a distance of
25-40 cm / 10-16 in.
Note:
If you change the distance for
Drive Past Wire
,
the distance will change along the boundary wire in all
parts of the work area.
4.5 Accessories
In
Accessories
you can change the settings of the
product accessories.
22
- Settings 2369 - 001 - 05.02.2024
To Next Page
Loading...
Need help?
General
