To prepare Weekly Every
year
Every
third year
Examine the skid plate and skid plate bearing. O
Examine the rubber bellows in the cutting height adjustment system. O
Examine the rubber bellows for the collision columns. O
Replace the rubber bellows for the collision columns. O
Examine and clean the airflow filter. O
Replace the airflow filter. O
Do a check of the tightening torque of chassis screws. O
Open the chassis and replace all sealing strips. O
Last step
Use a software service tool to do a function test of the functions of the product. O
6.3 Clean the product
CAUTION: Do not use a high-pressure
washer to clean the product. Do not use
solvents for cleaning.
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass. Clean the product
with a brush or running water from a water hose.
Husqvarna recommends to use a special cleaning and
maintenance kit. Speak to your Husqvarna servicing
dealer for more information.
6.3.1 To clean the blade discs and blade
disc guard
Examine the blade disc and blades and clean the blade
disc guard weekly.
1. Put the product onto its side.
2. Clean the blade discs and the blade disc guard
with a brush and running water.
6.3.2 To clean the chassis and body of the
product
To clean the product fully, the top cover and the body of
the product can be removed. If the product is dirty, use a
weak soap solution if necessary. Use a brush or a water
hose to clean the product. Do not use a high-pressure
washer to clean the product.
1. Set the product to OFF.
2. Carefully pull the top cover at the rear.
3. Hold the chassis with one hand and remove the
body with a fast and short pull upwards and
towards the front of the product.
28
- Maintenance 2369 - 001 - 05.02.2024
To Next Page
Loading...
Need help?
General
