6.5 Replacement of the blades
WARNING: Husqvarna can only
guarantee safety if you use Husqvarna
original blades with the embossed crowned
H-mark logotype.
WARNING: You must replace the
screws when you replace the blades. The
used screws can wear quickly and make the
blade come loose, this can cause serious
injury.
Replace worn or damaged blades for a safe operation.
Replace the blades regularly for a satisfactory cut result
and a low energy use. All 3 blades and screws must
be replaced at the same time to get a balanced cutting
system.
6.5.1 To replace the blades
1. Set the product to OFF.
2. Put the product with the blade disc up on a clean
and soft surface.
3. Rotate the skid plate until the holes align with the
screws for the blade.
4. Remove the 3 blades and 3 screws.
5. Attach new blades and screws.
6. Make sure that the blades can move freely.
30
- Maintenance 2369 - 001 - 05.02.2024
To Next Page
Loading...
Need help?
General
