Message Cause Action
Guide 1 not found
Guide 2 not found
Guide 3 not found
The guide wire you have installed before is
not found.
Examine if the guide wire is not correctly
connected to the charging station or the
boundary wire. Examine if there is a break
in the guide wire. Refer to
Finding breaks in
the loop wire on page 39
.
GPS navigation prob-
lem
Problem with the GPS assisted navigation
equipment.
Restart the product. If the problem stays,
speak to your authorized service center.
Weak GPS signal
The GPS signal is blocked in large parts of
the work area.
If possible, remove objects that can cause a
blockage of the GPS signal.
Disable the GPS navigation function and use
the lawn coverage function. Refer to
Lawn
coverage on page 22
.
7.2 LED indicator of the charging station for boundary wire installation
The LED indicator of the charging station is green when the installation is correct. If the LED indicator of the charging
station is not green, follow the troubleshooting table below.
Speak to your local Husqvarna representative or go to www.husqvarna.com for more information.
LED indicator
Cause Action
Constant green The signals of the charging station are good. No action is necessary.
Flashes green The signals of the charging station are good
and
ECO mode
is enabled.
No action is necessary.
Flashes blue The boundary wire is not connected to the
charging station.
Connect the boundary wire to the charging
station.
The boundary wire is damaged. Replace the damaged section of the boun-
dary wire with new boundary wire.
Flashes red Interference in the antenna of the charging
station.
Speak to your local Husqvarna representa-
tive.
Constant red Error in the circuit board or incorrect power
supply in the charging station.
The error must be corrected by an authorized
service technician. Speak to your local Husq-
varna representative.
2369 - 001 - 05.02.2024 Troubleshooting - 37
To Next Page
Loading...
Need help?
General
