5. Remove the joysticks.
6. Install in opposite sequence.
5.3.11 To replace the jog wheel
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Remove the center console. Refer to
To remove and
install the center console on page 17
.
5. Push a screwdriver through the hole to loosen the
jog wheel.
6. Remove the jog wheel.
7. Install in opposite sequence.
5.3.12 To replace the display (Automower
®
435X
AWD)
1. Remove the front top cover. Refer to
To remove and
install the front top cover on page 13
.
2. Remove the front bumper tail. Refer to
To remove
and install the front bumper tail on page 14
.
3. Remove the front body. Refer to
To remove and
install the front body on page 14
.
4. Remove the center console. Refer to
To remove and
install the center console on page 17
.
5. Remove the application board. Refer to
To remove
and install the application circuit board and stop
sensor on page 40
.
6. Remove the display holder.
7. Remove the seal.
22 - Repair instructions 1061 - 001 -
To Next Page
Loading...
