Husqvarna AUTOMOWER 550 - To Remove and Install the Center Console

9. When you connect the cables make sure to put the
cables in the cable holders. To put the cables into
position in the upper chassis:
To put the cables into position in the lower chassis:
Note: Attach a new warranty seal. The warranty seal
must be included and unbroken for the warranty to be
valid.
CAUTION: The cable routing is important to
avoid disturbance of the loop sensor board.
CAUTION: Always connect the HMI cable
before the power cable to avoid current spikes
that may harm the circuit boards or the battery.
CAUTION: Make sure that no cables are
pinched.
CAUTION: Replace the sealing strip each time
you install the upper chassis.
6.5 To remove and install the center console
1. Remove the body. Refer to To remove and install
the body on page 13 .
2. Remove the upper chassis. Refer to To remove and
install the upper chassis on page 14 .
3. Disconnect the cable for the center console from the
application circuit board.
4. Pull out the rubber grommet.
5. Disconnect the cable.
6. Remove the 3 screws.
7. Lift up the center console.
8. Install in opposite sequence.
1541 - 001 - Repair instructions - 15