8 Troubleshooting
8.1 Messages
The table below contains fault and information messages which can appear in the product.
Note: Refer to the Operator's manual for more information about how to rectify errors.
Messages
Number Message Cause Action
0 No message Indicates that no message is stor-
ed.
1 Outside working area The product is not within the work
area.
Put the product within the virtual
boundaries of the work area.
The work area slopes too much at
the virtual boundary.
Check that the virtual boundary
has been installed according to
the instructions.
The product finds it hard to distin-
guish the charging station signal
because of an installation close
by.
Put the product in the charging
station and generate a new loop
signal.
If the product is within the F-field
close to the charging station, the
signal can be disturbed from
magnetic objects (fences, rein-
forcement steel) or buried cables
close by.
Change the position of the charg-
ing station.
1541 - 001 - Troubleshooting - 37
To Next Page
Loading...
