6.6 To replace the top cover
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the 10 screws that hold the top cover to the
body.
3. Remove the clips from the bottom of the body and
pull the top over out.
4. Use a flat screwdriver to press the 4 clips and pull
up the front top cover.
5. Install the new top cover into the clips.
6. Install in opposite sequence.
6.7 To replace the rear bumper
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the 4 screws that hold the rear bumper to
the body.
3. Remove the rear bumper.
4. Install in opposite sequence.
Note: For 550H EPOS the 2 outer screws have a
different tightening torque. Refer to
Screw fasteners
on page 35
.
6.8 To replace the front bumper 550H EPOS
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the 6 screws that hold the front bumper to
the body.
3. Remove the front bumper.
4. Install in opposite sequence.
16 - Repair instructions 1541 - 001 -
To Next Page
Loading...
