Husqvarna AUTOMOWER 550 - To Replace the Rear Joysticks; To Replace the START;STOP Button

6.14 To replace the rear joysticks
1. Remove the body. Refer to To remove and install
the body on page 13 .
2. Remove the 4 screws that hold the rear joysticks to
the upper chassis.
3. Lift up and remove the rear joysticks.
4. Install in opposite sequence.
6.15 To replace the START/STOP button
This section gives information on how to remove all
parts. For service or to replace a spare part, all steps
may not be necessary.
1. Remove the body. Refer to To remove and install
the body on page 13 .
2. Remove the center console. Refer to To remove and
install the center console on page 15 .
3. Open the hatch fully to the START button and pull it
forward.
4. Remove the screw (A) for the LED housing
assembly.
B
A
5. Remove the screw (B) for the START/STOP button
support.
6. The START/STOP button will be released.
7. Install the new START/STOP button.
8. Install in opposite sequence.
Note: Make sure that the spring for the hatch is
positioned correctly.
Note: The cable routing for the LED cable is important.
1541 - 001 - Repair instructions - 19