4. Push the clips with a flat screwdriver and pull the
rear collision sensor circuit board down to remove it.
5. Install in opposite sequence.
6.17 The battery system
WARNING: Use only original batteries
recommended by the manufacturer. Product
safety cannot be guaranteed with other
batteries. Do not use non-rechargeable
batteries.
The battery is considered to be fully charged when the
battery reaches 80% of the total capacity. To charge the
battery to 100% would take too long since the charging
current is low. The most rational way of using Li-ion
batteries is therefore to stop charging at 80%. The
maximum utilised capacity is thus 80% of the battery’s
total capacity.
The battery is maintenance-free, but has a limited life
span. The battery is expected to last for 3000 - 4000
charging cycles. The normal charging current is 7 A.
6.17.1 To replace the batteries
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the upper chassis. Refer to
To remove and
install the upper chassis on page 14
.
3. Disconnect the battery cables from the motor control
circuit board.
4. Remove all cables from the cable holders.
1541 - 001 - Repair instructions - 25
To Next Page
Loading...
