3. Disconnect the cable from the lift sensor circuit
board.
4. Push the clip and remove the lift sensor circuit
board.
5. Install in opposite sequence.
6.16.10 To replace the front collision circuit board
The magnet on the front edge underneath the body must
be installed correctly for the correct operation of the
collision sensor. If this is not the condition, the magnet
holder which is a part of the charging plate installation
must be replaced. Refer to
To replace the charging
plates on page 26
.
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the upper chassis. Refer to
To remove and
install the upper chassis on page 14
.
3. Disconnect the cable from the front collision circuit
board.
4. Push with a flat screwdriver on the clip and pull out
the holder.
5. Push the clips with a flat screwdriver to remove the
collision circuit board.
6. Install the new sensor circuit board.
7. Install in opposite sequence.
6.16.11 To replace the rear collision circuit board
The magnet on the right rear joystick must be installed
correctly for the correct operation of the collision sensor.
If this is not the condition, the front joystick must be
replaced. Refer to
To replace the rear joysticks on page
19
.
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the upper chassis. Refer to
To remove and
install the upper chassis on page 14
.
3. Disconnect the cable from the rear collision circuit
board.
24 - Repair instructions 1541 - 001 -
To Next Page
Loading...
