5. Remove the 4 screws for the battery holder.
6. Remove the battery holder.
7. Remove the battery from the battery holder.
8. Install a new original Husqvarna battery/batteries in
the battery holder.
9. Install in opposite sequence.
6.17.2 To replace the charging plates
If the battery of the product does not recharge this may
be because of worn or damaged charging plates. Also
do a check of the contact plates on the charging station.
Refer to
To replace the contact plates in the charging
station on page 31
.
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the screw for the holder of the charging
plates.
3. Lift up and remove the holder.
4. Remove the charging plates and the charging plates
cable.
5. Install in opposite sequence.
6.18 The cutting system
6.18.1 To replace the blade motor
1. Remove the body. Refer to
To remove and install
the body on page 13
.
2. Remove the upper chassis. Refer to
To remove and
install the upper chassis on page 14
.
3. Disconnect the blade motor cable from the motor
control circuit board.
4. Remove the cable from the cable holders in the
lower chassis.
26 - Repair instructions 1541 - 001 -
To Next Page
Loading...
