Note: The
Weather timer
is reset if the product
does not operate for more than 50 hours, or if a
Reset of all user settings
is done. The
Weather
timer
is not changed if a
Reset of schedule
settings
is done.
To set the Weather timer
1. Select
Settings > Operation
in the app.
2. Select
on/off
to enable or disable the
Weather timer
.
Note: If the cutting results are not
satisfactory, the cutting time can be
adjusted. Set the cutting time
High
to cut for
a longer time or
Low
to cut for a shorter
time.
3. Select
Save
.
3.8.2.3 ECO mode
If
ECO mode
is enabled, it switches off the signal
in the charging station, when the product is
parked or is charging.
Note: Use
ECO mode
to save energy and avoid
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
1. Select
Settings > Operation
in the app.
2. Select
on/off
to enable or disable the
ECO
mode
function.
3. Select
Save
.
3.8.3 Installation
In the Installation menu it is possible to
adapt the settings of the product for
best mowing result.
3.8.3.1 To find the charging station
The product can do a search for the charging
station in 3 methods:
•
Charging station signal
•
Follow boundary wire
(
Virtual boundary
)
•
Follow guide
(
Virtual guide
)
The factory setting is set to use the 3 search
methods at the same time. Use the factory
setting to find the charging station as fast as
possible and to keep the risk of tracks on the
lawn to a minimum. The product always starts to
search for the
Charging station signal
. After a
specified time interval, the product also uses
Follow guide
(follow
Virtual guide
) and
Follow
boundary wire
(follow
Virtual boundary
).
Causes why the product cannot follow the
Virtual
guide
or
Virtual boundary
.
• Obstacles near the
Virtual boundary
or
Virtual guide
have not been isolated.
• The charging station, the
Virtual boundary
or
the
Virtual guide
are not installed correctly.
Refer to
Installation on page 17
.
To change the signal range of the charging
station
For some installations it is necessary to decrease
the signal of the charging station. For example
when the charging station is put near an obstacle
such as a bush or wall and the signal reaches to
the other side of the obstacle. The product knows
that it is close to the charging station and tries to
dock, but the objects prevents it. The options are
min
,
avg
(average) or
max
.
Note:
The recommended setting is
max
. It is
usually better to move the charging station, than
to decrease the range of the charging station
signal.
1. Select
Settings > Installation > Find charging
station
in the app.
2. Select signal range.
3. Select
Save
.
To set the delay time for the Virtual guide and the
Virtual boundary
1. Select
Settings > Installation > Find charging
station
in the app.
2. Select
on/off
to enable or disable to follow
the
Virtual guide
or
Virtual boundary
.
3. Move the horizontal bar to set the time
delay.
34
- Installation
1460 - 002 - 06.04.2020
To Next Page
Loading...
