must be selected in the Automower
®
Connect
app. In this mode, the operator must move the
product manually between the main area and the
secondary area. The product mows for a selected
period of time or until the battery is empty. When
the battery is empty, the product stops with the
message
Needs manual charging
. Put the
product in the charging station to charge the
battery. When the battery is charged, the product
moves out of the charging station and stops. The
product is now prepared to start operation, but
needs confirmation from the operator first. In the
Secondary area
mode, the product operates for a
selected period of time or until the battery is
empty.
Note: If you want to cut the main area after the
battery is charged, set the product to
Main area
mode and change Site in the EPOS app before
you put the product in the charging station.
4.4 Operating mode - Park
When selecting
Park
the following operation
selections can be chosen.
• Park until further notice
• Start with schedule
• Parking duration
4.4.1 Park until further notice
The operation mode Park means that the product
goes back to the charging station where it stays
until a new operation mode is selected and the
START button is pushed.
4.4.2 Start on next schedule
The product goes back to the charging station
where it stays until the next schedule setting let
the product to operate. Use the operation
selection to stop operation temporary, for
example for irrigation or for games on the lawn.
4.4.3 Parking duration
The product goes back to the charging station
and stays for the selected park duration. Use the
operation selection to temporary stop an ongoing
mowing cycle and let the product to stay in the
charging station.
4.4.4 Operating mode - Pause
When selecting
Pause
in the Automower
®
Connect app, the product stop the current activity
and pause. The product is paused until either
Park
or
Start
is selected in the Automower
®
Connect app.
4.5 To stop the product
1. Push the STOP button on top of the product.
The product stops and the blade motor stops.
4.6 To switch off the product
1. Press the STOP button on top of the
product.
2. Set the Main switch to position
0
.
WARNING: Always switch off the
product using the main switch if it
requires maintenance, or if the product
must be moved outside the work area.
4.7 To adjust the cutting height with
Automower
®
Connect
The cutting height can be adjusted from MIN to
MAX
1. Select
Settings > Cutting height
.
2. Move the horizontal bar to set the cutting
height.
3. Select
Save
.
1460 - 002 - 06.04.2020
Operation - 41
To Next Page
Loading...
