22. Plate for post attachment
2
23. Screws for installation of the reference
station on a post
24. Screw for installation of the reference station
25. Screws for installation of the reference
station on a wall
26. Power supply
3
27. Low voltage cable
1.6 Symbols on the product
These symbols can be found on the product.
Study them carefully.
WARNING: Read the
user instructions before
operating the product.
WARNING: Disable the
product before working on
or lifting the product.
WARNING: Keep a safe
distance from the product
when operating. Keep
your hands and feet away
from the rotating blades.
WARNING: Do not ride
on the product. Never put
your hands or feet close
to or under the product.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product’s emissions are set out in
Technical data on page 60
and on the
rating plate.
It is not permitted to dispose this
product as normal household waste.
Ensure that the product is recycled in
accordance with local legal
requirements.
The chassis contains components
which are sensitive to electrostatic
discharge (ESD). The chassis must
also be resealed in a professional
manner. For these reasons the chassis
shall only be opened by authorized
service technicians. A broken seal can
result in the entire or parts of the
warranty no longer being valid.
The low voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low
voltage cable. Be careful when
trimming edges where the cables are
placed.
1.7 Symbols in the EPOS app
The battery level symbol
shows the battery state of
charge.
The radio signal symbol
shows the radio signal
strength from the refer-
ence station. The filled
circles shows the strength
of the signal.
The position symbol
shows the level of accu-
rate position of the prod-
uct. All circles must be fil-
led for an automatic oper-
ation of the product.
2
2 dimensions are included
3
The appearance may differ depending on market
6 - Introduction
1460 - 002 - 06.04.2020
To Next Page
Loading...
