Note: Operate the product in a straight line
for 7 m / 7 ft. in front of the charging station
and let the product enter the charging
station.
6. Operate the product with the
appDrive
in a
straight line for 2 m / 7 ft. into the charging
station.
7. Select
Set point
to make a set point on the
map. The app draws straight lines between
the set points. Use many set points to get
smooth curves.
Note: Select
Undo
to remove the latest set
point on the map.
8. Select
Set point
when the product is in the
charging station.
9. Select
Save
.
3.6.16 To activate the Site
To use a
Site
, you first must enable the
Site
. The
Virtual boundary
and
Virtual guide
are grey when
they are disabled.
1. Select
Load site
and select the
Site
you will
to enable.
2. Select
Activate site
.
3. Enter the PIN code.
3.7 Automower
®
Connect
The app gives 2 modes of connectivity: Long-
range cellular connectivity and Short-range
Bluetooth
®
connectivity.
The product can connect to mobile devices that
have the Automower
®
Connect app installed.
Automower
®
Connect is a free app for your
mobile device. The Automower
®
Connect app
gives extended functions to your Husqvarna
product. You can:
• See the status of your product.
• Change settings to your product.
• Get extended product information.
• Get an alarm if the product moves out of the
work area.
• See statistics of your product.
Note:
All countries do not support Automower
®
Connect because of regional specified cellular
systems. The included Automower
®
Connect
lifetime service only applies if there is a third part
sub-supplier of 2G/4G available in the operational
area.
The Automower
®
Connect app is preferable if
you have one or few products installed. For users
with several products we recommend you to use
Husqvarna Fleet Services
™
. Refer to
Husqvarna
Fleet Services
™
on page 39
.
3.7.1 Dashboard
The dashboard shows the current status of the
product both visually and in text. It is very easy to
control the product by selecting the options, for
example
Park
.
In the lower part of the dashboard there are
shortcuts to the
Schedule settings
and the
Map
.
The dashboard also shows symbols according to
below:
1. The battery status shows the battery state of
charge. A flash is shown over the battery
symbol when the product charges its
battery. A plug is shown over the battery
symbol when the product is in the charging
station without charging.
2. Cutting height.
For more information about the operating modes
Start, Park
and
Pause
, refer to
Operation on
page 40
.
3.7.2 Account
In this menu there is an overview of the account
settings and you can log off from the app.
1460 - 002 - 06.04.2020
Installation - 31
To Next Page
Loading...
