3.5.3 To examine where to install the Virtual
guide
• Install the
Virtual guide
in a line at a
minimum of 2 m / 7 ft. in front of the charging
station.
• Make as much free area as possible to the
left of the
Virtual guide
when facing the
charging station. Refer to
To examine where
to put the charging station on page 18
.
• Install the
Virtual guide
minimum 30 cm / 12
in. from the
Virtual boundary
.
• Do not make sharp bends when you install
the
Virtual guide
.
• If the work area has a slope, install the
Virtual guide
diagonally across the slope.
3.6 Installation of the product
3.6.1 General steps for installation of the
product
For full instructions follow the installation
instructions in
Installation of the product on page
22
.
1. Install the charging station.
2. Install the reference station.
3. Install the Automower
®
Connect app to your
mobile device.
4. Pair the product with the Automower
®
Connect app. Do the basic settings in the
start up sequence in the Automower
®
Connect app.
5. Restart the product to enable pairing mode.
6. Pair the product with the EPOS app.
7. Make a
Site
with
Work area
,
Charging
station
,
Virtual guides
and
Stay-out zones
in
the EPOS app.
8. Activate the
Site
.
9. Use Automower
®
Connect app to do
settings for the product.
3.6.2 Installation tools
• Mobile device with EPOS app installed.
Included in carton.
• Screwdriver, Torx 20.
• Hex key, 4 mm.
• Hex key, 8 mm. Included in the carton.
• Hex key, 5 mm.
Note:
The EPOS app must be used with the
supplied mobile device.
3.6.3 Installation of the charging station
Read and understand the instructions about the
charging station. Refer to
To examine where to
put the charging station on page 18
.
WARNING: Obey national regulations
about electrical safety.
WARNING: The product is only to be
used with the power supply unit
supplied by Husqvarna.
22 - Installation
1460 - 002 - 06.04.2020
To Next Page
Loading...
