WARNING: Do not put the power
supply at a position where there is a
risk that it can become wet. Do not put
the power supply on the ground.
WARNING: Do not encapsulate the
power supply. Condensed water can
harm the power supply and increase
the risk of electrical shock.
WARNING: Risk of Electric Shock.
Install only to an residual-current
device (RCD) when connecting the
power supply to the wall socket.
Applicable to USA/Canada. If power
supply is installed outdoors: Risk of
Electric Shock. Install only to a
covered Class A GFCI receptacle
(RCD) that has an enclosure that is
weatherproof with the attachment plug
cap inserted or removed.
CAUTION: Do not make new holes in
the charging station plate.
CAUTION: Do not put your feet on the
baseplate of the charging station.
WARNING: The power supply cable
and extension cable must be outside
the work area to avoid damage to the
cables.
When connecting the power supply, only use a
power outlet that is connected to an residual
current device (RCD).
3.6.3.1 To install the charging station
1. Put the charging station in the selected area.
2. Attach the charging station to the ground
with the supplied screws.
3. Connect the low-voltage cable to the
charging station.
4. Put the power supply at a minimum height of
30 cm / 12 in. Refer to
To examine where to
put the power supply on page 19
.
5. Connect the power supply cable to a
100-240V power outlet.
6. Put the low-voltage cable in the ground
outside the work area. Use stakes or bury
the cable.
7. Put the product in the charging station to
charge the product.
3.6.3.2 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on
the charging station has a green light.
2. If the indicator LED lamp does not have a
green light, do a check of the installation.
Refer to
To install the charging station on
page 23
and
LED indicator lamp on the
charging station on page 54
.
3.6.4 Installation of the reference station
Read and understand the instructions about the
reference station. Refer to
To examine where to
put the reference station on page 17
.
You can install the reference station on a post or
a wall.
1460 - 002 - 06.04.2020
Installation - 23
To Next Page
Loading...
