Husqvarna AUTOMOWER EPOS - 3.5.2 To examine where to put the Virtual boundary

• Put the charging station in the work area
along the Virtual boundary.
• Put the charging station in the lower section
of the work area.
• Minimum distance to a work area behind the
charging station (A) is 3 m / 10 ft.
A
3.5.1 To examine where to put the power
supply
WARNING:
Do not cut or extend the
low-voltage cable. There is a risk of
electrical shock.
CAUTION: Make sure that the blades
on the product do not cut the low-
voltage cable.
CAUTION: Do not put the low-voltage
cable in a coil or below the charging
station plate. The coil causes
interference with the signal from the
charging station.
• Put the power supply in an area with a roof
and protection from the sun and rain.
• Put the power supply in an area with good
airflow.
• Use a residual-current device (RCD) when
you connect the power supply to the power
outlet.
Low-voltage cables of different lengths are
available as accessories.
3.5.2 To examine where to put the Virtual
boundary
CAUTION: If the work area is adjacent
to water bodies, slopes, precipices or a
public road, the Virtual boundary must
have a protective wall. The wall must
be minimum 15 cm / 6 in. in height.
CAUTION: Do not let the product
operate on gravel.
CAUTION: Do not make sharp bends
when you install the Virtual boundary .
135º
135º
90º
CAUTION: For careful operation
without noise, isolate all obstacles
such as trees, roots and stones.
Note: Make a blueprint of the work area before
you install the
Virtual boundary and Virtual guide .
• The product must receive sufficient satellite
signals in the complete work area.
1460 - 002 - 06.04.2020
Installation - 19