3.6.13.1 To make a Work area
1. Connect the product and the EPOS app.
Refer to
To connect the product and the
EPOS app on page 28
.
2. Make sure that the product and the EPOS
app are connected.
3. Select
Load site
and select the
Site
where
you want to install the
Work area
.
4. Select the plus sign.
5. Select
Work area
.
6. Operate the product with the
appDrive
around the
Work area
to install the
Virtual
boundary
. Refer to
To operate the product
with appDrive on page 28
.
CAUTION: Do not lift and move
the product between the set point.
Use
appDrive
for a correct
installation.
7. Select
Set point
to put a set point on the
map. The app draws straight lines between
the set points. Use many set points to get
smooth curves.
Note: Select
Undo
to remove the latest set
point on the map.
8. Select
Done
to connect the first and last set
points to complete the
Work area
.
9. Enter the name for the
Work area
.
10. Select
Save
.
3.6.14 Stay-out zones
Stay-out zones
are made inside the work area
where the product is not allowed to operate. The
Stay-out zone
is specified by the
Virtual
boundary
. A saved
Stay-out zone
cannot be
edited. If you want to make changes, you need to
make the
Stay-out zone
again.
Note:
The
Virtual boundary
can be installed
clockwise and counterclockwise.
3.6.14.1 To make a Stay-out zone
1. Connect the product and the EPOS app.
Refer to
To pair the product and the EPOS
app on page 28
.
2. Select
Load site
and select the
Site
where
you want to install the
Stay-out zone
.
3. Select the plus sign.
4. Select
Save
.
CAUTION: Do not lift and move
the product between the set point.
Use
appDrive
for a correct
installation.
5. Operate the product with the
appDrive
around the
Stay-out zones
to install the
Virtual boundary
. Refer to
To operate the
product with appDrive on page 28
.
6. Select
Set point
to install a set point on the
map. The app draws straight lines between
the set points. Use many set points to get
smooth curves.
Note: Select
Undo
to remove the latest
Set
point
on the map.
7. Select
Done
to connect the first and last set
points to complete the
Stay-out zone
.
8. Enter the name for the
Stay-out zone
.
9. Select
Save
.
3.6.15 Virtual guide
• The product can follow the
Virtual guide
to
remote parts of the work area and to find the
charging station.
• You can install up to 3
Virtual guides
in the
work area.
• Do not install the
Virtual guide
across itself.
• You can install the
Virtual guide
across other
installed
Virtual guides
.
• The
Virtual guide
cannot be installed across
a
Stay-out zone
.
• The
Virtual guide
is allowed to go across the
Virtual boundary
.
3.6.15.1 To make a Virtual guide
1. Put the product in a remote part of the work
area where the product will follow the
Virtual
guide
.
2. Connect the product and the EPOS app.
Refer to
To connect the product and the
EPOS app on page 28
.
3. Select
Load site
and select the
Site
where
you will make the
Virtual guide
.
4. Select the plus sign.
5. Operate the product with
appDrive
to make
the virtual guide.
30
- Installation
1460 - 002 - 06.04.2020
To Next Page
Loading...
