8. Obey the instructions in the Automower
®
Connect app.
Note: It is only necessary to pair the Automower
®
Connect app and the product once.
Note: To disconnect the Automower
®
Connect
app, the app must be fully closed down.
3.6.7 To pair the product and the EPOS app
1. Open the EPOS app on your mobile device.
2. Switch on the product.
Note: During start up the LED status
indicator on the product is white.
3. Select the product you want to pair in the list
in the EPOS app. When the LED status
indicator starts to flash yellow the
Bluetooth
®
pairing mode is active for 3
minutes.
4. Make sure that the mobile device and the
product are paired.
Note: It is only necessary to pair the mobile
device and the product once.
3.6.8 To connect the product and the EPOS
app
Note:
Before you connect the product and the
EPOS app, you must first pair the EPOS app and
the product the first time you use the EPOS app.
Refer to
To pair the product and the EPOS app
on page 28
.
1. Open the EPOS app on your mobile device.
2. Select the product you want to connect to in
the list in the EPOS app.
Note:
The product can only be connected to one
app at the time. Close the app that is not to be
used and try to pair again.
Note: To disconnect the EPOS app from the
product, select
Settings > Disconnect
in the
EPOS app.
3.6.9 To pair the product and reference
station
1. Enter the
Dashboard
in the EPOS app.
2. Select
Connect reference station
.
3. Select
Next
.
4. Select the reference station in the list.
5. Select
Done
.
3.6.10 To operate the product with appDrive
You can use the
appDrive
to operate the product
and to install a
Site
in the EPOS app.
• Select
Dashboard > appDrive
in the EPOS
app to operate the product.
Note: You can only use the buttons (A) to
(E) and not add set points in the map.
• Select the plus sign and select
Work area,
Stay-out zone, Virtual guide
or
Charging
station
to use
appDrive
for installation.
• Use the buttons to operate the product:
a) Use the up button (A) to move the
product forward.
b) Use the down button (B) to move the
product rearward.
c) Use the left arrow button (C) to rotate
the product to the left.
d) Use the right arrow button (D) to rotate
the product to the right.
e) Use the center button (E) as a joystick
to move and rotate the product in any
direction.
f) Use the Set point (F) to add a set point
in the map.
g) Use the Undo button (G) to remove the
latest set point in the map.
To Next Page
Loading...
