EasyManua.ls Logo

Husqvarna AUTOMOWER EPOS - 3.6.5 To install the Automower Connect app; 3.6.6 To do the basic settings

Husqvarna AUTOMOWER EPOS
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6. Install the screw (Torx 20) on the arm of the
reference station.
T20
7. Connect the low-voltage cable to the
reference station and the power supply.
8. Attach the low-voltage cable to the wall from
the reference station to the power supply
with cable ties.
CAUTION:
If the low-voltage
cable is not attached tightly with
cable ties it can be damaged in
hard wind.
9. Put the power supply at a minimum height of
30 cm / 12 in. from the ground. Refer to
To
examine where to put the power supply on
page 19
.
10. Connect the power supply cable to a
100-240V power outlet.
11. Make sure that the LED status indicator on
the reference station is solid green. Refer to
LED indicator lamp on the reference station
on page 55
.
3.6.5 To install the Automower
®
Connect
app
1. Download the Automower
®
Connect app on
your mobile device.
2. Sign up for a Husqvarna account in the
Automower
®
Connect app.
3. An e-mail is sent to the registered e-mail
address. Follow the instructions in the e-mail
in less than 24 hours to validate your
account.
4. Log in to your Husqvarna account in the
Automower
®
Connect app.
3.6.6 To do the basic settings
When the product is switched on for the first time,
there are some basic settings to do before the
product can start to operate. You must for
example pair the product and the charging
station, and you can choose to enable the theft
protection in GeoFence. Refer to
GeoFence on
page 38
. You must also pair the product and the
Automower
®
Connect app to be able to change
the settings and operate the product. Refer to
Automower
®
Connect on page 31
.
1. Switch on the product.
Note:
The Bluetooth
®
pairing mode is
active for 3 minutes. If pairing has not
been successful within this time period,
switch off the product. Wait until the LED
status indicator is not lit, and then switch
on the product again.
2. Enter the factory PIN code.
3. Log in to your Husqvarna account in the
Automower
®
Connect app.
4. Start Bluetooth
®
on your mobile device.
5. Select
My mowers
in the Automower
®
Connect app, and then select the plus sign
(+).
6. Select model. The Automower
®
Connect
app searches for available products within
short-range (Bluetooth
®
).
7. Select product.
1460 - 002 - 06.04.2020
Installation - 27

Table of Contents

Related product manuals