A
Site
can only have one
Work area
. It has 0-3
Virtual guides
and a number of
Stay-out zones
.
You can disable and enable the functions in the
EPOS app to adapt the site for temporary
operation. There can be maximum one
Charging
station
. You can make a number of
Sites
for
different parts of the yard. Only one
Site
at the
time can be enabled with the
Schedule
. A
Site
with no
Charging station
and no
Virtual guides
installed is operated as a
Secondary area
in the
Automower
®
Connect app.
Note:
It is recommended to have a maximum of
400 set points for each
Site
.
3.6.11.1 To make a Site
1. Connect the product and the EPOS app.
Refer to
To connect the product and the
EPOS app on page 28
.
2. Select
Site
or
Load site
.
3. Select the plus sign.
4. Enter a name for the
Site
.
5. Select
Save
.
3.6.12 To set the position and direction of
the charging station
Set the position and direction of the charging
station to make the product enter the charging
station correctly.
1. Put the product 2 m / 7 ft. straight in front of
the charging station.
2. Open the EPOS app on your mobile device.
3. Make sure that the EPOS app and the
product are connected.
4. Select
Load site
and select the
Site
where
the charging station is to be installed.
5. Select the plus sign.
6. Select
Charging station
.
7. Operate the product with the
appDrive
function and move it straight into the
charging station. Refer to
To operate the
product with appDrive on page 28
.
Note:
Do not lift and move the product
between the set point. Use the
appDrive
for
a correct installation.
8. Select
Set point
.
9. Select
Done
.
3.6.13 Work area
A
Work area
is specified by the
Virtual boundary
.
A saved
Work area
cannot be edited. If you want
to make changes, you need to make the
Work
area
again.
Note:
The
Virtual boundary
can be installed
clockwise and counterclockwise.
1460 - 002 - 06.04.2020 Installation - 29
To Next Page
Loading...
