Symptoms Cause Action
Uneven mowing
results.
The product works too few hours per
day.
Increase the mowing time. Refer to
Schedule on page 32
.
The
Weather timer
senses that the
lawn has been mowed more than it ac-
tually has. Increase the intensity level
in the
Weather timer
. Disable the
Weather timer
if this does not help.
The
How often?
setting is incorrect in
relation to the layout of the work area.
Note: Not applicable if GPS assisted
navigation is enabled.
Check that the correct
How often?
val-
ue is selected.
The shape of the work area requires
the use of
Area 1-5
for the product to
find its way to all remote areas. Note:
Not applicable if GPS assisted naviga-
tion is enabled.
Use
Area 1-5
to steer the product to a
remote area. Refer to
Lawn Coverage
on page 35
.
Work area is too large. Try to limit the work area, or to extend
the work time. Refer to
To calculate the
schedule setting on page 33
.
Dull blades. Replace all the blades. Refer to
To re-
place the blades on page 44
.
Long grass in relation to the set cutting
height.
Increase the cutting height and then
successively lower it.
Accumulation of grass by the blade
disc or around the motor shaft.
Check that the blade disc rotates freely
and easily. If not, screw off the blade
disc and remove grass and foreign ob-
jects. Refer to
Chassis and blade disc
on page 43
.
The map of the
Site is not correct.
During installation the product where
manually moved between the set point
and not operated with
appDrive
.
Use the
appDrive
to install the
Work
area
,
Stay-out zone
or
Virtual guide
again. Refer to
Installation of the prod-
uct on page 22
.
The product dis-
connects from the
EPOS app when it
enters or stands in
the charging sta-
tion.
The product is in power save mode
when it is in the charging station and
the charging is completed.
Pull out the product from the charging
station.
If it occurs during installation the power
to the charging station can temporary
be disconnected during the installation.
58 - Troubleshooting
1460 - 002 - 06.04.2020