Maintenance Daily maintenance
before operation
Maintenance interval
in hours
25 50 100 200
Lubricate the belt adjuster. X X
Examine and adjust the steering wires O O
Examine the muffler and heat deflector O
Examine the cutting deck for damages O
Change the spark plug O
Adjust the parking brake. O
Do a check of and adjust the throttle wire O
Clean the cooling fins on the engine and the transmission O
Clean the engine and the transmission O
Do a check of/adjust front and rear wheel rotation speed, RC
320Ts AWD model only
O O
Do a check of the belts O O
Do a check of the battery O
Do a check of the fuel hose. Replace it if necessary O
Change the oil in the transmission O O
Change filter in the transmission, RC 320Ts AWD model only O O
Change the spin-on filter, servo, RC 320Ts AWD model only O O
To clean the product
CAUTION: Do not use a high pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which cause damage to the
product.
Clean the product directly after use.
• Before you stop the engine, let the auger run empty
for 10 seconds to clear it from remaining grass.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, use a brush to remove
grass cuttings and dirt from on and around the
transmission, the transmission air intake, and the
engine.
• Use running water to clean the product. Do not use a
high pressure.
• Do not point the jet at electrical components or
bearings. Cleaning additives usually increase the
damage.
• To clean the cutting deck, put it in the servicing
position and hose it down with water.
• Hose down the inner surface of the collector with
water.
• Clean the auger in- and outlets.
• When the product is clean, start the product for a
short period to blow off remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
20 63 - 007 - 20.06.2017
To Next Page
Loading...
Need help?
General
